7
Getting Started
Setting the voltage selector
(voltage selector equipped
models only)
Check that the voltage selector on the rear
panel of the unit is set to the local power line
voltage. If not, set the selector to the correct
position using a screwdriver before connecting
the AC power cord to a wall outlet.
Connecting the AC power
cord
Connect the AC power cord to a wall outlet.
VOLTAGE SELECTOR
110-120V 220-240V
This Unit Can Use the
Following Discs
The unit can use three types of discs as
follows:
Audio CD
Discs with these logos can be played by
both DECK A (the CD player section)
and DECK B (the CD-R or CD-RW
recording section) of the unit.
Audio CD-R
Discs with this logo are recordable
only one time. When you finalize the
disc (page 24), you can play it in either
DECK A (the CD player section) or
DECK B (the CD-R or CD-RW
recording section), or any conventional CD player
(you may not be able to play it in some CD players),
including home, car, and portable models. (An
unfinalized disc can be played only in DECK B.)
When you buy a CD-R, please note that you must buy
an audio CD-R. A CD-R designed for computer use
will not work in this unit.
Audio CD-RW
Discs with this logo are recordable,
and also re-writable. When you
finalize the disc (page 24), you can
play it in either DECK A (the CD
player section) or DECK B (the CD-R
or CD-RW recording section), and CD-RW
compatible players. They will not play back in most
current CD players unless the player is CD-RW
compatible. (An unfinalized disc can be played only
in DECK B.)
When you buy a CD-RW, please note that you must
buy an audio CD-RW. A CD-RW designed for
computer use will not work in this unit.
This logo means that an unit is
compatible with Audio CD-R and
Audio CD-RW (both Audio CD-R and
Audio CD-RW can be used).
To Next Page
Loading...
Need help?
Power
Inputs
Weight and Dimensions
