Sony RM-E300 - Changing Cut-out Points

change the cu point
1 After step 5, press the PGM — button so that the CUT
OUT indication of PGM 5 lights.
2 Press the GO TO button.
3 Locate the new cut-out point.
4 Press the ENTRY button at the new cut-out point to be
memorized.
When the following cut-in or cut-out point has not been set Note
After changing the cut-in or cut-out point, the following cut-in or The editing point can be changed once after pressing the — PGM
cut-out point can be set continuously. or PGM = button. To change again, press the < PGM or PGM >
button again.
57