Sony SLV-696HF - VCR TV Program Recording; Stopping VCR Recording; Pausing VCR Recording

Recording TV Programs
Before you begin, check the following points:
@ Make sure that the connections have been made correctly
(see pages 6 to 14).
@ Check the input mode indicator in the display window of
the VCR. ,
Press INPUT SELECT to light the TUNER indicator in the
display window.
CAUTION:
Television programs, films, video cassettes and other
materials may be copyrighted. Unauthorized recording
of such material may be contrary to the provisions of the
copyright laws. Also, use of this recorder with cable
television transmission may require authorization for the
cable television transmission and/or program owner.
Recording TV Programs
1 insert a cassette.
The VCR turns on automatically (auto power on).
2 Turn on the TV.
3 if your TV is connected to both VHF/UHF OUT and
LINE OUT on the VCR, select the input for the VCR.
4 if your TV is connected only to VHF/UHF OUT, set the
TV
to
the
correct
channel
(CH
3
or
CH
4),
then
press
TV/VTR so that the VTR indicator lights up.
Skip this step if your VCR is connected to both
the VHF/UHF OUT and LINE OUT.
5 Select the channel to be recorded with CHANNEL +/-
or channel number buttons and ENTER.
6 Select sP or EP with TAPE SPEED (SP/EP).
To select the best recording tape speed, see “Maximum
Recording Time of a Cassette” on page 28.
7 Press the two @ REC buttons on the Remote
Commander at the same time, or the @ REC button
on the VCR.
To stop recording:
Press H STOP.
To pause the cassette:
Press Il PAUSE. To resume recording, press II PAUSE.
When the recording pause mode lasts for approximately
5 minutes, the VCR enters the stop mode.
When the cassette reaches its end:
The cassette rewinds to the beginning and the power
remains on.
Basic Operations | 33
sweifioug Al Guipsosay / yoeghetg |