Sony STR-DA5600ES - Quick Click Settings

133
GB
Adjusting Settings
Lets you turn the function that activates the
switching hubs on the rear of the receiver and
allows external control devices to control the
receiver on or off even when the receiver is in
standby mode.
x OFF
The network function turns off when the
receiver is in standby mode.
x ON
The network function works even when the
receiver is in standby mode.
In addition, the start-up time of the network
function is reduced after the receiver is turned
on.
Note
The server function of the receiver works while the
receiver is in standby mode, even if “Network
Standby” is set to “OFF.”
Quick Click settings
You can make settings to control components
connected to the receiver using the on-screen
remote.
See “Operating Each Component Using the
On-screen Remote (Quick Click)” (page 142)
for details on using the on-screen remote.
Selects the source component that is to be
operated.
x Preset Mode
Customizes the remote to match the source
components connected to your receiver.
x Learn Mode
Allows the remote learn codes.
x Reset
Resets both programmed codes and learned
codes.
Selects the common component such as a TV,
projector or lights that is to be operated.
x Preset Mode
Customizes the remote to match the common
components such as the TV, the projector and
the lightings connected to your receiver.
x Learn Mode
Allows the remote to learn codes.
x Reset
Resets both programmed codes and learned
codes.
Sets several commands in a sequential order as
a single command.
Network Standby
Source Component
Common Component
Macro