Sony STR-SE591 - Hooking Up the Components; Unpacking; Before you get started

“FES RS ane i See
the...
fee
Grea:
te eShogmG sg sei
ents: :
This eee describes how. to connect - ee
various audio and video components
‘to the receiver. Be sure to read the. .
sections for the components you have
before youactually;connect them'to,, ..
the receiver.
é geen ke
ei d sigh i
ee
ema Cl Bega pee LE Tre tet an he
BPH Beet Bee BAR PPE aT,
“qs
st PE bAive? Sree? paivelis
PS gegevens
SSS a ee a I
Unpacking
Check that you received the following items with the
remote:
¢ FM wire antenna (1)
© AM loop antenna (1)
¢ Audio/video/control S connecting cord (1)
* Control S connecting cord (1)
¢ FM antenna adapter (1)
STR-DE935 only
¢ Remote commander RM-LJ302 (remote) (1)
* R6 (size-AA) alkaline batteries (3)
STR-DE835/SE591 only
© Remote commander RM-PP402 (remote) (1)
© R6 (size-AA) batteries (2)
Inserting batteries into the remote
Insert R6 (size-AA) batteries with the + and — properly
oriented in the battery compartment. When using the
remote, point it at the remote sensor & on the receiver.
For details, refer to the operating instructions supplied
with your remote.
‘ When to replace batteries
Under normal conditions, the batteries should last for about 3
months (STR-DE935 only) or 6 months (STR-DE835 /SE591 onl:
When the remote no longer operates the receiver, replace all
batteries with new ones.
Notes
* Do not leave the remote in an extremely hot or humid place.
¢ Do not use a new battery with an old one.
* Do not expose the remote sensor to direct sunlight or lightin;
apparatuses. Doing so may cause a malfunction.
* If you don’t use the remote for an extended period of time,
remove the batteries to avoid possible damage from battery
leakage and corrosion.
* This remote is designed for use with alkaline batteries only.
not use a combination of different battery types (STR-DE935
only).
Before you get started
¢ Turn off the power to all components before making
any connections.
* Do not connect the AC power cords until all of the
connections are completed.
¢ Be sure to make connections firmly to avoid hum an:
noise.
¢ When connecting an audio/video cord, be sure to
match the color-coded pins to the appropriate jacks «
the components: yellow (video) to yellow; white (le
audio) to white; and red (right, audio) to red.