Sony STR-SE591 - Direct Tuning

syse2peoig Bulaiacey ;
PRESET +/—
Numeric buttons MEMORY
Brief descriptions of buttons used to
receive broadcasts
PRESET +/~: Press to scan all preset radio stations.
DIRECT: Press this button to enter a frequency directly
using the numeric buttons.
Numeric buttons: Press to enter a numeric value when
inputting the frequency directly, presetting radio stations,
or tuning to preset stations.
TUNING +/-: Press to scan all available radio stations.
FM MODE: If “STEREO” flashes in the display and the
FM stereo reception is poor, press this button to improve
the sound. You will not be able to enjoy stereo effect but
the sound will be less distorted.
Note -
If “STEREO” does not appear at all even when the FM broadcast
is received normally, press this button to turn on the “STEREO”
indication.
FM: Press to select the FM band.
AM: Press to select the AM band.
MEMORY: Uses for memorizing preset stations.
SHIFT: Press to select a memory page (A, B, or C) for
presetting radio stations or tuning to preset stations.
TUNER: Selects the tuner.
44
Direct
Tuning
For details on the buttons used in this section, see “Brief
descriptions of buttons used to receive broadcasts” on thi:
page.
1 Press TUNER to light the button up.
The last received station is tuned in.
2 Press FM or AM to select the FM or AM band.
Press DIRECT.
4 Press the numeric buttons to enter the frequency.
Example 1: FM 102.50 MHz
S*ooe coe
Example 2: AM 1350 kHz
(You don’t have to enter the last “0” when the tuning scale is
set to 10 kHz.)
1 3 5
ca3*co3*c5
If you cannot tune in a station and the
entered numbers flash
Make sure you’ ve entered the right frequency. If not,
repeat Steps 3 and 4.
If the entered numbers still flash, the frequency is not
used in your area.
5 If you've tuned in an AM station, adjust the
direction of the AM loop antenna for optimum
reception.
6 Repeat Steps 2 to 5 to receive another station.
Cit you try to enter a frequency that is too precise for the
tuning scale
The entered value is automatically rounded up or down.
Tuning scale for direct tuning is:
FM: 50 kHz
AM: 10 kHz (to change to 9 kHz, see page 54.)