– 21 –
THIS NOTE IS COMMON FOR PRINTED WIRING
BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed
in each block.)
For schematic diagrams.
Note:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and
1
/
4
W or less unless otherwise
specified.
•
¢
: internal component.
• 2 : nonflammable resistor.
• 1 : fusible resistor.
• C : panel designation.
For printed wiring boards.
Note:
• X : parts extracted from the component side.
• Y : parts extracted from the conductor side.
•
p : parts mounted on the conductor side.
•
®
: Through hole.
•
¢
: internal component.
• b : Pattern from the side which enables seeing.
• U : B+ Line.
• V : B– Line.
• H : adjustment for repair.
• Voltages and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal pro-
duction tolerances.
• Circled numbers refer to waveforms.
• Signal path.
F : FM
f : AM
L : AUDIO (AV INPUT)
g : MD/VIDEO
i : VIDEO (AV INPUT)
E : PB (DECK A)
G : REC (DECK B)
J : CD
• Abbreviation
EE : East European model.
EA3 : Saudi Arabia model.
EA4 : Israel model.
EA : Middle East model. (Saudi Arabia and Israel)
AUS : Australian model.
SP : Singapore model.
MY : Malaysia model.
TW : Taiwan model.
JE : Tourist model.
AR : Argentine model.
TH : Thai model.
CH : Chinese model.
Note: The components identified by mark ! or dotted line
with mark ! are critical for safety.
Replace only with part number specified.
• Indication of transistor
C
These are omitted
EB
Q
C
These are omitte
To Next Page
Loading...
