Parts Identification
34
4 Display section
A RF (radio frequency) indications
The number of dots indicates the RF
input level.
B AF (audio frequency) indication
Appears whenever the output audio
signal is stronger than the reference
level.
C BATT (battery) indication
Shows the battery condition.
For details, see “Power Supply” on
page 38.
D GP (group)/CH (channel)
indication
Shows the reception channel group
and channel number. Each time you
press the SET button, the channel
indication changes as follows.
For details, see “Settings” on page
47.
5 + (+ selection) / – (– selection/
reset) buttons
Press these buttons to set the reception
channel and frequency. The “–”
button resets the accumulated battery
use time to “00:00”. These buttons can
also be used to adjust the monitor
level.
6 Battery compartment
Accommodates two LR6 (size AA)
alkaline batteries.
For details on how to insert the
batteries, see “Power Supply” on
page 38.
7 SET button
Press to change display parameters.
For details, see “Settings” on page
47.
8 POWER switch
Turns the power of the tuner ON or
OFF.
Reception
channel group
and number
Reception
frequency
Accumulated
battery use
time
Press
the
SET
button.
AF
RF
BATT
CH
A
B
C
To Next Page
Loading...
