18
Projecting an Image
3 The cursor will disappear if the deflection
range limit is reached.
Automatically adjusts Phase, Pitch and Shift of projected image while a
signal is input from a computer (APA (Auto Pixel Alignment))
Press APA on the remote commander. Press again to cancel during the setting.
If Smart APA is set to On, executes APA automatically when a signal is input (page 24).
1 Press the ?/1 key on the main unit or the Remote Commander.
The shutdown message appears.
If you do not press any of the keys for a while, the projector will turn off.
If you press ?/1 on the projector or remote commander while the shutdown message is on
the screen, the projector will restart.
2 Unplug the AC power cord from the wall outlet.
After step 1, the fan continues to run for a while to reduce internal heat, however, you may
also unplug the AC power cord before the fan stops.
To turn off without displaying confirmation message
Hold the ?/1 key on the main unit pressed for a few seconds.
Example of cursor display:
You can adjust in all directions.
You can adjust only towards the
right and downwards.
Turning Off the Power
To Next Page
Loading...
