Sony VPL-VW528 - Writing of Adjustment Data

3-3 (E)
VPL-VW5
20
3-3. Writing of Adjustment Data
The writing procedure of 3DGamma/LookUpTable/CSMatrixTable/UGM/SLC/panel chiral/optical unit
assembly shift/panel alignment data/color sensor/serial data is as follows.
1. Prepare the USB memory.
2. Copy the following files directly under the drive of the USB memory.
CSMatrixTable.csv
ColorSensorMatrixTable
OptUnit.csv
pd_slc.csv
pd_uf.csv
pd_gamma.csv
pd_ugm.csv
pd_bpc.csv
pd_clk.csv
pd_dwec.csv
pd_dwec_ratio.csv
pd_pwm.csv
pd_regi_lens_adj.csv
pd_uf_std.csv
pd_gamma_std.csv
SetSerial.csv
*1
*1: Used only for the writing by the serial reading. Not required when replacing only the optical unit assembly.
3. Turn on the power of this unit.
4. Insert the USB memory into this unit.
5. Enter the service mode. (Refer to Section 2-1-2.)
6. Change the value of Display Engine 17 DE/Flash Put of Device Menu to “1”.
7. Return to the list of Device Menu, and check the value of Display Engine 17 DE/Flash Put. Repeat
until the value becomes “0”.
8. Perform “Save to memory”.