1-2 (E)
VPL-VW520
1-3. Tighten Torque
Tighten the each screw with the torque below.
. BVTP3 x 8: 0.80 ?0.12 N.m (8.0 ?1.2 kgf.cm)
. BVTP3 x 12: 0.80 ?0.10 N.m (8.0 ?1.0 kgf.cm)
. K3 x 8: 0.80 ?0.12 N.m (8.0 ?1.2 kgf.cm)
. PS3 x 8: 0.50 ?0.12 N.m (5.1 ?1.2 kgf.cm)
. PSW3 x 8: 0.60 ?0.02 N.m (6.1 ?0.2 kgf.cm)
. PSW3 x 10: 0.80 ?0.12 N.m (8.0 ?1.2 kgf.cm)
. PSW4 x 12: 1.40 ?0.20 N.m (14 ?2.0 kgf.cm)
. PSW5 x 8: 1.40 ?0.20 N.m (14 ?2.0 kgf.cm)
. Stopper screw (B3 x 10): 0.80 ?0.10 N.m (8.0 ?1.0 kgf.cm)
. Tapping PWH3 x 8: 0.80 ?0.12 N.m (8.0 ?1.2 kgf.cm)
When using the torque driver with the notation of cN.m, interpret it as follows.
Example: 0.8 N.m = 80 cN.m
To Next Page
Loading...
