129
To check DME assignment status
While the [MON] button is pressed, the lit color of the
[DME1] to [DME4] buttons shows the DME assignment
status.
Lit green: DME currently being monitored
Lit amber: DME which can be monitored
Not lit: Unassigned DME
Other Key Adjustments
Using an external processed key
To select key fill and key source signals for a processed
key keyer on the AUX bus or edit preview bus, press
[PROC KEY].
The [PROC KEY] button is lit amber, and the key fill and
key source signals processed on the currently selected
keyer are assigned to re-entry signals PROC V and PROC
K.
When DME is selected on the keyer, the key fill and key
source signals with DME effect applied are assigned.
The PROC V and PROC K signals on each switcher bank
cannot be selected using the cross-point buttons on the
same switcher bank.
Using frame memory feed
To select key fill and key source signals for a processed
key keyer on the frame memory source buses, press the
[FM FEED] button.
The [FM FEED] button momentarily is lit amber, and the
key fill and key source signals processed on the currently
selected keyer are assigned to the frame memory source 1
and 2 buses. The [PROC KEY] button is lit amber
simultaneously.
When DME is selected on the keyer, the key fill and key
source signals with DME effect applied are assigned.
Using the show key function
While the [SHOW KEY] button is pressed, the key source
signal for the processed key appears on the specified
output.
You can also set the show key function so that it is
maintained for a preset time after the [SHOW KEY] button
is pressed.
The show key function output and preset time are
configured in the Setup menu.
For details, see “Setting Show Key” (page 469).
Using auto delegation
To couple the selection of the buttons in the following
control blocks so that the delegation selection switches
automatically in the key control block, press the [AUTO
DELEG] button, turning it on.
• Transition control block: [KEY1] to [KEY8] buttons
• Cross-point pad on the cross-point control block: Key 1
to 8 bus delegation buttons [KEY1] to [KEY8]
• 1st row on cross-point control block (key/AUX bus
delegation mode): [KEY1] to [KEY8] buttons
• Memory recall section on the Flexi Pad control block
(key operation mode): [KEY1] to [KEY8] buttons
• Key fader control block: Key delegation buttons
Returning the key adjustment values to
their defaults
Press and hold the key type selection buttons (LUM, LIN,
CRK, PTN) to restore the key adjustment values to their
defaults (see page 109).
Key modify clear
Simultaneously pressing and holding a bank delegation
button (M/E1 to M/E5, P/P) and keyer delegation button
(KEY1 to KEY8) sets the selected key settings to the initial
status settings.
For details about initial status, see “Power-On (Startup)
State Selection” (page 398).
Note
To Next Page
Loading...
