Sony XVS-7000 - Basic Copy and Swap Operations

187
Matte data copy and swap
You can copy or swap matte data between color
generators.
Color data copy and swap
You can copy or swap color data between color generators.
a) Excluding DME ch4.
DME channel copy and swap
You can copy and swap the channel data between DME
channels.
Basic Copy and Swap Operations
Copy/Swap menu
Carry out copy/swap operations in the Copy/Swap menu.
You can select the following targets in the Copy/Swap
>Copy/Swap menu.
• M/E: Copying and swapping M/E data
• Key: Copying and swapping key data
• Wipe: Copying and swapping wipe data
• DME Wipe: Copying and swapping DME wipe data
• Matte: Copying and swapping matte data
• Color: Copying and swapping color data
• DME: Copying and swapping data for each DME
channel
Copying or swapping
This section describes copying or swapping wipe data as
an example.
1 Open the Copy/Swap >Copy/Swap >Wipe menu
(3113).
The status area shows lists for the copy/swap source on
the left, and the copy/swap destination on the right.
2 In the <Data Select> group, select one of the
following.
Wipe: The operation applies to wipe settings.
Key Wipe: The operation applies to independent key
wipe settings.
3 Select data for the copy/swap source and copy/swap
destination
4 Press [Copy] to copy, or [Swap] to swap.
To undo a copy or swap
Press [Undo] to return to the state before the copy or swap
was carried out.
Coping using button operation
You can carry out the following copy using button
operations on the control panel.
Basic button operation
Press and hold the copy source button and press the copy
destination button.
You can undo the last operation using [Undo] in the Copy/
Swap menu (see page 187).
Example of copying
This example describes copying of key 1 on the M/E-1
bank to key 2 on the M/E-2 bank.
Target bank Target keyer and data
M/E-1
M/E-2
M/E-3
M/E-4
M/E-5
PGM/PST
Key 1 to key 8 • Matte data for key
fill
• Matte data for key
edge fill
Matte data for wipe border edge
Color
background
• Matte data for color background 1
• Matte data for color background 2
Target bank Target keyer and data
M/E-1
M/E-2
M/E-3
M/E-4
M/E-5
PGM/PST
Key 1 to key 8 • Colors 1 and 2 for
key fill
• Colors 1 and 2 for
key edge fill
• Zabton color data
Colors 1 and 2 for wipe border
Color data for preset color mix
Color
background
• Colors 1 and 2 for color background 1
• Colors 1 and 2 for color background 2
DME ch1 to ch4 • Background
•Border
•Sepia
• Light
• Shade
• Drop shadow
a)
•Trail
Copy Using buttons
M/E copy [SNAPSHOT] button on the Flexi Pad
control block
Keyer copy Copy source selection: [KEY1] to
[KEY8] delegation buttons on the key
control block
Copy destination selection: [KEY1] to
[KEY8] key operation buttons on the
Flexi Pad control block
Wipe copy [WIPE] button on the Flexi Pad control
block
DME wipe copy [DME WIPE] button on the Flexi Pad
control block