10
Note: Before placing the PoE injector:
Ì Do not cover the PoE injector or block the airflow to the PoE with any
foreign objects. Keep the PoE away from excessive heat and humidity and
free from vibration and dust.
Ì Ensure that the cable length from Ethernet network source to the AP30
does not exceed 100 m (330 ft). The PoE is not a repeater and does not
amplify the Ethernet data signal.
LED display
Off Power off
Yellow continuously Power on
Green continuously A remote terminal is connected
Green blinking Overload state or short-circuit
Interfaces
Input (Data In) 1 x 10/100 Base-TX
Output (Data & Power Out) 1 x 10/100 Base-TX, plus 50 VDC
Installing the PoE injector
1. Connect an Ethernet cable to the Data & Power Out interface.
2. Connect the other end of this Ethernet cable to the Ethernet interface of
the AP30.
3. Connect an Ethernet cable to the Data In interface.
4. Connect the other end of this Ethernet cable to your network switch.
5. Connect the AC power cord from the scope of supply to the
PD-3501/AC.
6. Connect the AC power cable to an AC outlet (100 – 240 VAC).
Technical specifications
Sophos AP30
LAN interfaces 1 x 10/100 Base-TX
Wireless interfaces 802.11 b/g/n 2.4 GHz
Antennas 3 x directional internal antennas
Power supply 100-240 VAC, 50/60 Hz, max. 0.5 A
Weight 230 g / 0.507 lbs
Dimensions W x H Ø 125 mm, height 60 mm
Chassis Plastic housing, white
Mounting Desktop / ceiling
Temperature 0 °C to 45 °C (operating)
-20 °C to 70 °C (storage)
5 % to 95 % relative humidity non-considering
Certifications CE, FCC , VCCI, MIC, RoHS, WEEE
LED
Data & Power Out
Data In
Power
Sophos AP30 Operating Instructions
To Next Page
Loading...
Need help?
General
