Sophos AP10 User Manual

13
Introduction
We are pleased to welcome you as new Sophos Access Point customer. To
install and configure the access, point may refer to the following documents:
Ì Sophos Access Points Security Notes & Regulatory Compliance: Notes on
access point security
Ì Sophos Access Points Quick Start Guide: System peripheral connection in
a few steps
Ì Sophos AP50 Operating Instructions: Notes on the commissioning of the
access point
Ì Sophos UTM/ASG Administration Guide: Configuring the UTM hardware &
software appliance
The instructions must be read carefully prior to using the device and should
be kept in a safe place. You may download all user manuals and additional
documentation from the Astaro Knowledgebase via: www.astaro.com/kb.
Navigate to the main topics Manuals / Guides.
Controls
Power (LED display)
Off Power off
On continuously Power on
Blinking rapidly Firmware update
Blinking slowly No connection to the Sophos UTM
LAN connection (LED display)
On continuously Network connection, no activity
Blinking Network activity
Wireless LAN access with 2.4 GHz (LED display)
On continuously Network connection, no activity
Blinking Network activity
Wireless LAN access with 5 GHz (LED display)
On continuously Network connection, no activity
Blinking Network activity
Interfaces and buttons
WPS button
Currently not supported
OI
Power on/off switch
DC 12V IN Power
Reset Currently not supported
PoE/LAN 10/100/1000 Base-TX interface
10/100/1000 Base-TX
Reset
Power
Power on/off switch
Sophos AP50 Operating Instructions

Sophos AP10 Specifications

General

Brand	Sophos
Model	AP10
Category	Wireless Access Point
Language	English