2.2: HARDWARE I/O & CONTROL
GETTING STARTED > HARDWARE
2.2: Hardware I/O And Control
RESET
Recessed push switch used to reset the unit.
To reset Network settings ONLY, switch the unit on while holding down the reset button for at least ten seconds.
For a full system reset, see section 3.0.2.
FOOTSWITCH
Footswtich connector used to toggle FX Mute on and off.
Use a footswitch with a quarter-inch jack connection. The unit will auto-detect the connector type, though the
footswitch itself must be a non-latching type.
USB Connectors 1 & 2
MaybeusedforShowleimportandexport(section8),andsoftwareupdates.
There are USB connections on the front panel of the unit for audio recording and playback.
ETHERNET
Standard RJ45-wired connector for use with wired Ethernet.
A wired Ethernet conenction to the Ui is the most secure. See section 10.1 for more details on network settings
and configurations.
HDMI Connector (Ui16 Only)
Supports HDMI Video standard
The feature is not yet implemented.
Ui12, Ui16 User Manual
PWR
Power Connector & Switch
The Ui mixer has a power adapter with threaded locking ring. Insert the connector and screw the locking ring onto
the socket to prevent accidental removal and to ensure a satisfactory electrical connection for best performance.
Use the power switch with the reset button (other side panel) to reset the unit to factory default settings.
To Next Page
Loading...
Need help?
General
