Ui12, Ui16 User Manual
5.3.1: AFS
2
CHANNEL EDIT > GRAPHIC EQ > AFS
2
5.3.1: AFS
2
AFS
2
MODE
Choose LIVE, FIXED, or LOCK
Fixed mode is for pre-performance set-up, Live mode is for use during performance, and LOCK prevents changes
to the current filters status.
SENSITIVITY
Adjust the input level feeding the AFS
2
detector and make AFS
2
more or less prone to mark a
signal as feedback.
Setting this parameter high will allow AFS
2
to detect the feedback and notch it out more quickly. Conversely,
setting it low will cause AFS
2
to be a little more hesitant to set a filter on the feedback until it reaches a higher
level.
BYPASS
Bypass the AFS
2
process.
You need to bypass the process while setting up for Fixed Mode set-up (‘ringing out’)..
Manual AFS
2
Set-up in FIXED mode (Ringing Out The System)
1)MakesureallltersareclearedandsettheAFS
2
process to Bypass using the blue bypass button.
2) Perform a sound check and set up a rough mix for all microphones that will be active during the
performance. Take note of the output fader position for the aux master or stereo master that you are ringing
out – your TARGET GAIN will be around 5dB above this (see step 6).
3) If noise gates are being used on active mics – including inside FX processors, bypass them before
ringing out the system. You can re-enable them once the ring-out procedure is complete.
4) Have the musicians stop playing and fully lower the master bus faders. NOTE: When ringing out the
system in Fixed Mode, any sustained sound detected by AFS
2
willtriggerFixedlterstobeset.Therefore,
make sure the microphones are active, but there is no appreciable signal present at the mics.
5) Ensure the musicians are not playing, then set the FILTER MODE parameter to FIXED.
6) Un-bypass the AFS
2
process then slowly raise the master fader until you reach your target gain
(describedinstep2)orrunoutofFixedModelters,whicheverhappensrst.
7) Lower the Master bus fader back to performance level.
8)SettheFILTERMODEparametertoLIVE.ThesystemisnowreadyforuseandanyavailableLivelters
willbeavailableforon-the-yfeedbacksuppressionduringtheperformance.
To Next Page
Loading...
Need help?
General
