Source Audio Soleman - Remote Tap Tempo and External Switches; Remote Tap Tempo via CC; External Footswitch Configuration; Performing a Factory Reset

SA165 Soleman User’s Guide 26
Use CC for Remote Tap Tempo
As an alternative to outputting MIDI Clock, the Soleman can output Continuous Control messages
when the Tap Tempo Footswitch has been pressed, a setup commonly known as remote tap tempo.
Use this option when the receiving MIDI equipment is set up for remote tap tempo operation.
The CC controller number can be set using the Tap Tempo CC Val parameter.
External Footswitch Options
The function of the external footswitches is set with the External Switch 1 and External Switch 2
Function Global options.
External Footswitch 1 Options:
1. Scene/List/Panel UP (increment)
2. Scene/List/Panel DOWN (decrement)
3. Mode Select (cycles through Scene, Set List, Panel modes)
4. Tap Tempo (Higher Accuracy)
External Footswitch 2 Options:
1. Scene/List/Panel UP (increment)
2. Scene/List/Panel DOWN (decrement)
3. Mode Select (cycles through Scene, Set List, Panel modes)
4. Tap Tempo (Lower Accuracy)
See the External Footswitch Connections section for details on setting up the hardware.
Factory Reset
If you wish to return the Soleman to its factory settings, eliminating all user data and restoring all
options to their defaults, navigate to the Factory Reset screen in the Edit Menu and then press and
hold the Remove button.
When the factory reset operation begins, the screen will show an “In Progress” screen, followed by a
system reset when the operation is complete.
S e n d C C a s T A P
D i s a b l e d
T a p T e m p o C C V a l
0
E x t . S w i t c h 1 :
S c n / L s t / P n l U P
F a c t o r y R e s e t
H o l d R e m o v e