SA165 Soleman User’s Guide 4
MIDI Cable Connection
Use a standard 5-pin MIDI cable to connect one of the Soleman’s MIDI outputs (labeled MIDI OUT) to
the MIDI input of the target device. In the case of this example, the Neuro Hub is used.
Expression Connections
Using a ¼” TRS plug, connect the expression input to a passive expression pedal, if you have one.
Setting the Mode
The Soleman has three basic modes of operation: Scene, List, and Panel. For this example, the Scene
mode will be used. Scene mode, the most basic mode of operation, sends program change messages
(by default) on the MIDI outputs. In this example, these program change messages will be used to
activate scenes stored in the Hub.
The three LEDs on the top of the Soleman interface indicate the active mode. By default, the
Soleman should be in Scene mode (with the corresponding LED lit). If Scene mode is not active,
simply press the mode button to toggle through the available modes until Scene mode is selected.
Changing Scenes
Once Scene mode is active, use the Previous and Next footswitches to cycle from one scene to
another. The Hub should receive the message and change scenes accordingly.
To Next Page
Loading...
