SP Controls PixiePro PX2-MP-IR - Page 24

Configuration Setting Descriptions
Group 1 - Core Functions
CorefunctionsettingsdeterminebehaviorofPixiePro.
Setting 1 - Multiple-Device TCM Mode (toggle)
EnablethissettingtoallowtheTCMtocontrolmultipledevices.Disabletoalwayscontrolasingle
devicewiththeTCMmodule.SeeSection IX Operation formoreinformation.
Default:Enabled(Multiple-DeviceMode)
Setting 2 - “Device 0” on TCM in Multiple-Device Mode (toggle)
TheTCMmayswitchtoadevice0profilewhenthecurrentlyselectedSourcebuttonispressed
again.Thisallowsuserstoalwaysaccessadesiredcodesetregardlessofwhichsourceiscurrently
selected.SeeProgramming the Transport Control/Menu Module onpage15formoreinformation.
Default:Disabled
Setting 3 - Input Selection Lights on TCM Persist in Single-Device Mode (toggle)
WhentheTCMonthePixieProhasbeenconfiguredtobeinSingle-Devicemode,enablingthisset-
tingwillcausethemostrecentlypressedinputselectionlighttobecomebrighterafterbeing
pressed.Havingthissettingdisabledwillcausethelightingontheinputselectionbuttonstoremain
constantwhileinSingle-Devicemode,regardlessofwhichbuttonwasmostrecentlypressed.
Default: Disabled
Setting 4 - Defeat In-Progress Macro on Button Press (toggle)
Whenenabled,pressingabuttonwhilethePixieProisintheprocessofsendingamacrowilldis-
cardtheremainderofthemacrobeingsentandsendthenewcode.Whendisabled,buttons
pressedwhilethePixieProissendingamacrowillhavenoeffect.
Default: Disabled
Setting 5 - Fixed-Length Code Learning (rangeof0-0through3-7,0-0islowestsetting)
WhenthePixieProlearnsacode,thisvaluedetermineshowmanyrepetitionsofthecodethe
PixieProwillrecord.Whenthecodeissentaspartofamacro,thiswilldeterminethelengththe
PixieProwillsendthecodeforinasinglesend.Whenthe PixieProsendsthisbuttonindependently,
thisvaluewillnotaffecthowlongitissent,unlessSetting 6 isenabled.
Default:0-1
Setting 6 - Fixed-Length Code Learning Applies to Single-Code Learning (toggle)
Whenthissettingisenabled,thecodedurationrecordedduringlearning(configurableinSetting 6
above)willbetheminimum-lengthsendforanycode.Thiswillpreventtheuserfrominadvertently
pressingabuttonfortooshortatimetocontrolthedevice.
Default:Enabled
Setting 7 - High-Frequency Carrier Default (toggle)
Whenenabled,thePixieProwillassigna455kHzcarrierfrequencytoanIR signalifitdoesnot
detectacarrierfrequency.SP Controlsrecommendsthatthissettingremainenabled(default).
Default: Enabled
21