SP Controls PixiePro PX2-MP-IR - Page 28

Group 4 - Interface Settings
Configurethe“lookandfeel”ofthePixiePro.
Setting 1 - Button Click On/Off (toggle)
DeselectButtonClicktomutethePixieProaudiofeedbackthataccompaniesbuttonpressesduring
normaloperation.
Default:Enabled(PixieProemitsaclickingsoundwhenbuttonsarepressed)
Setting 2 - Button Click on Every Macro Send (toggle)
Whenenabled,the PixieProwillemitasingleclicksoundforeverycodesentfrominamacro
sequence.Whendisabled,the PixieProwillbeeponlyasingletimewhenamacrosequenceissent.
Default:Disabled
Setting 3 - LED Brightness Level (0-0through0-7)
SettheLEDbrightnesstoafixedlevel.IfthePixieProisconfiguredwithAmbient Light Adjust,this
settingdefinesthemaximumLEDbrightness.
Range:0-0=dim,0-7=bright
Default:0-7(maximum)
Setting 4 - Enable Ambient Light Adjust (toggle)
Whenenabled,thePixieProwillautomaticallyadjustdisplaybrightnesstomatchroomlightingcon-
ditions.Whendisabled,thePixieProdispalyrunsataconstantbrightnesslevel.
Default:Disabled
Setting 5 - Volume Animation (toggle)
Whenenabled,Volume Up/Volume Down commandsareindicatedbyavolumeLEDlevelstrobing
animation.
Default:Enabled
Setting 6 - Press-and-Hold Off (toggle)
SelecttorequireuserstopressandholdthePower Off buttonfortwosecondstosendtheoffcom-
mand.
Default:Disabled
Example - Setting Button Click Sound:PressAux 4 toselecttheInterface Settings group.Press
Source 1 toselectthe Button Click Sound settings.Use Volume Up/Volume Down totoggle
betweenonandoff.OnsettingisindicatedbyallvolumeLEDsilluminating,offsettingisindicated
byallvolumeLEDsdark.Oncetheappropriateselectionhasbeenmade,pressanypowerbuttonto
acceptselection.
25