27
ALARM GIVES FALSE ALARMS
Check position of Valet Switch a nd Reset usin g En able/Disable seque nce.
Bad Earth of Supply Connection. Check connection of BLACK earth wire.
Check connection of RED supply wire.
Post Ignition. Check that your vehicle does not
have any electrical circuit operating
when the vehicle is parked, i.e.
Hazard lights, radiator cooling fan,
etc.
Ultrasonic Detector too Sensitive. Check and re-adjust ultrasonic
sensor.
Shock Sensor too Sensitive. Check and re-adjust shock sensor.
Current Sensing too Sensitive. Decrease trigger sensitivity by
relocating RED wire to an alternative
12V position closer to the batter y.
Wiring Fault Test operation of all switches and
ensure all triggering connection are
secure and make good electrical contact.
To Next Page
Loading...
