Speck pumpen Normblock - 1 General; Principles; Installation of Partly Completed Machinery; Target Group

1 General
1.1 Principles
This operating manual is supplied as an integral part of the type series and variants
indicated on the front cover. The manual describes the proper and safe use of this
equipment in all phases of operation.
The name plate indicates the type series/size, the main operating data and the order
number. The series number uniquely identifies the pump (set) and serves as
identification for all further business processes.
In the event of damage, immediately contact Speck Pumpen to maintain the right to
claim under warranty.
Noise characteristics (⇨ Section 4.8 Page 21)
1.2 Installation of partly completed machinery
To install partly completed machinery supplied by Speck Pumpen refer to the sub-
sections under Servicing/Maintenance.
1.3 Target group
This operating manual is aimed at the target group of trained and qualified specialist
technical personnel. (⇨ Section 2.4 Page 8)
1.4 Other applicable documents
Table 1: Overview of other applicable documents
Document Contents
Outline drawing Description of mating and installation dimensions
for the pump (set)
Hydraulic characteristic curve Characteristic curves showing head, NPSH
required, efficiency and power input
Sub-supplier product literature Operating manuals and other product literature
describing accessories and integrated machinery
components
For accessories and/or integrated machinery components, observe the relevant
manufacturer's product literature.
1.5 Symbols
Table 2: Symbols used in this manual
Symbol Description
✓ Conditions which need to be fulfilled before proceeding with the
step-by-step instructions
⊳ Safety instructions
⇨ Result of an action
⇨ Cross-references
1.
2.
Step-by-step instructions
Note
Recommendations and important information on how to handle
the product
1 General
6 of 58
Normblock