14169000-IG, Edition 11.0
January 2018, Original document
25
Deployment Procedure
Start by placing your tripod with the Spectralink IP-DECT Server 400 (from your deployment tools)
where you plan the first base station to be:
l Place the first base station in a corner of the building so there is coverage in the corner.
Note:
Take picture of the placement and note it on a blueprint of the building.
l Make a call between the two handsets. During the deployment there must always be an active
call established.
Note:
Measurements are only valid on handsets in a connected call!
l Play music/talk into the handset without headset. Wear the headset and listen to the sound
quality all the time.
l At the same time as listening to the sound quality, use your handset to measure how far the
base station will cover sufficiently.
This is done by walking away from the base station with the Site Survey Handset and meas-
ure where the RSSI value drops below 70 and the Q value stays constant at 64. Do this
in all directions from the base stations.
For a description of the parameters and RPN values, see "Important Parameters" on page 17.
Note:
The handset can only measure correctly when off hook.
When measuring, carry the handset with your hands covering the antennas to
assimilate normal user conditions (heads or surroundings blocking the radio sig-
nals when holding the handset to the ear).
l To perform a site survey using a Spectralink Standard Handset (7522/7532,7622/7642,
7722/7742), enter Survey mode on the handset. For more information about using the
Spectralink IP-DECT Server 400/6500 and DECT Server 2500/8000 Synchronization and Deployment Guide
To Next Page
Loading...
