To Next Page

To Previous Page

The Steering Rate feature of the DX3 allows the steering servo travel to be increased or

decreased to the desired amount required. The values of the Steering Rate function are a

percentage based from the travel adjust value set in the Travel Adjust section.

Example: Travel adjust value 100%, Steering value 80% — Maximum steering rate is

now reduced to 80% of the maximum travel value (100%)

The Steering Rate function also works in conjunction with the Grip Lever B Steering Rate

function (page 32) and acts as the maximum rate available through Grip Dial B. This feature

allows the steering rate to be increased or decreased directly from the Grip Lever B while

racing to maximize the steering rate needed for the particular track conditions.

Accessing the Steering Rate Function

To access the Steering Rate Function, follow the steps below:

Press the MODE key until D/R STM

appears on the screen

MODE CHANNEL

ENTER

SYSTEM

Press the INCREASE or DECREASE

keys to achieve the desired steering

rate value

INCREASE DECREASE

CLEAR

DIRECT

+ –

1. Turn on the transmitter power switch.

2. Press the MODE key to enter the Function Mode.

3. Press the MODE key until D/R STM appears on the screen.

4. Press the INCREASE or DECREASE keys until the proper steering rate is achieved.

5. Press the MODE key to access the Sub-Trim function.

6. To exit the Function Mode, either turn off the transmitter power switch or press the

MODE and CHANNEL keys at the same time.

Steering Rate

(Function Mode)

stm

100

D/R

Indicates Steering Rate function

Indicates current

value

–

Spectrum DX3 User Manual

Questions and Answers: