26
① Insert the TF card into the main unit and power it on.
② The main unit will start the upgrade automatically upon powering
on. Do not remove the TF card during the upgrade process.
③ After the upgrade is complete, the main unit will go black. Discon-
nect the power at this point.
● Main unit firmware upgrade
③ Click on Zone A "Image" and select the downloaded latest firm-
ware.
④ Choose Zone B "Product" in the "Work Type" selection.
⑤ Check the TF card that has been inserted in the Zone D
"DevList" section. (It is recommended to temporarily remove any
other TF cards or USB drives)
⑥ Click Zone C "Burn" to start burning the card.
⑦ The Zone E "Output message" will display the progress of the
card burning. Do not remove the TF card during this process.
When the TF card reaches 100% progress and turns green, the
card burning is successful.
⑧ After successful card burning, click Zone F "Close" to exit the
program.
① Run the "PhoenixCard.exe" program.
② Click on Zone A "Image" and select the downloaded latest firm-
ware (.img file).
③ Choose Zone B "Product" in the "Work Type" selection.
④ Check the TF card that has been inserted in the Zone D
"DevList" section. (It is recommended to temporarily remove any
other TF cards or USB drives)
⑤ Click Zone C "Restore" to start restoring the card.
⑥ The Zone E "Output message" will display the progress of the
card restoration. Do not remove the TF card during this process.
⑦ After successful card restoration, click Zone F "Close" to exit the
program.
● TF card restore
① Insert the TF card into the main unit and power it on.
② Go to "Settings" - "Firmware Info" and check if the firmware
version has been updated.
● Check firmware
To Next Page
Loading...
