SPHINX Project Eight Service Manual
4
4. TECHNICAL SPECIFICATIONS
Bandwidth 0 - 500,000 Hz (+0/-3 dB)
Phase response error <1°
Gain 20 dB max.
THD+N (IHF-A) <0.008% (2nd harm., < 100 kHz and 6 V into 600 ohm)
<0.0015% (2nd harm., 10 – 20,000 Hz and 6 V into 600
ohm)
IMD <0.0015%
S/N ratio (IHF-A) >110 dB
Channel separation >110 dB
Inputs 2x XLR balanced
6x WBT cinch unbalanced
Level, nominal (for 1 V output) 0.16 V (-18 dBV)
Impedance XLR: 10 kohm / cinch: 50 kohm
Sensitivity (programmable for each input) adjustable between –9 dB and +9 dB
Outputs 2x XLR balanced
1x WBT cinch unbalanced
1x cinch Tape
level 10 V max. (20 dBV) (1 - 100,000 Hz, THD <0.001%)
impedance <10 ohm
Volume control Relay-controlled in steps of 0.2 dB
Range 100 dB
channel imbalance less than 0.2 dB
Sphinx Control 3x optical
OUT-1: 1 second delayed
OUT-2: normal
OUT-3: programmable via Auto On
Remote control full function
Mechanical decoupling of housings Transrotor absorbing 'pucks'
Power supply External, in completely separate housing
Supply capacitance 148,000 µF total
Power consumption 50 W
Dimensions (h x w x d) 68 x 482 x 328 mm (one housing only)
Weight 14 kg
This unit conforms to the EMC interference regulations issued by the EU and to the CE standards.
This unit complies with safety regulation VDE 0860 and therefore with international safety regulation IEC 65.
Technical specifications may be changed by SPHINX without prior notice if technical developments make this
necessary.
To Next Page
Loading...
