Page 17
Shutting down
Do not power the PC off until the SphygmoCor XCEL software and Windows software have been exited.
Wait 4 seconds after turning the computer OFF before turning it on again.
Caution: Exit the SphygmoCor XCEL software prior to shutting down the computer.
Equipment Calibration
The SphygmoCor XCEL System should be checked annually for calibration. For repairs, refer to qualified
service personnel as instructed by AtCor Medical. The device does not contain any user-serviceable or
reusable parts. Disassembly of the device by unauthorized personnel voids any warranty conditions.
Cleaning Instructions
To clean the SphygmoCor XCEL device, first unplug it from the computer and the power outlet. Using a
damp cloth with mild detergent, gently wipe the equipment. Do not use other cleaning agents. Ensure
excess liquids are wiped immediately from the equipment.
Caution: Do not spray cleaning agents or liquid directly on any components.
Notebook Batteries
Ensure when using the SphygmoCor XCEL System on notebook computers running on rechargeable
batteries that the batteries are fully charged. Do not use the system on low battery power. If the
notebook is abruptly shuts down, the SphygmoCor database may be corrupted. Consult the notebook
manufacturer’s user documentation regarding the safety and maintenance of the notebook
rechargeable battery.
Tonometer Care
The tip of the tonometer is a delicate and sensitive device, and can be easily damaged if dropped or
misused. Follow the guidelines below to ensure tonometer lifetime is maintained.
When the tonometer is not in direct use with the patient, protect the tonometer by placing it in the
storage holder in the tray or in the temporary storage holder on top of the SphygmoCor XCEL device.
Do not use this tonometer with any other instrumentation other than that supplied by AtCor Medical.
Do not use a tonometer from any other supplier. The SphygmoCor XCEL tonometer is intended to be
used in conjunction with the AtCor Medical SphygmoCor XCEL device only, which has a floating
(isolated) grounding system.
Disinfection Instructions for Tonometer and Cuffs
The SphygmoCor XCEL product is considered a “non-critical” device. Therefore a low-level disinfection
method has been provided to assist users to disinfect the tonometer and cuffs, which are the only
patient contacting component of the SphygmoCor XCEL System (see below).
For tonometer disinfection, use a 70% Isopropyl Alcohol (IPA) impregnated wipe or cloth for low-level
disinfection. Allow a contact time of at least 5 minutes.
For cuff cleaning, refer to the cleaning instructions accompanied in the cuff packaging.
To Next Page
Loading...