Spinfire Pro 2 - Ball Speed Adjustment; Spin Level Adjustment; Elevation Adjustment; Horizontal Angle Adjustment

14
Ball Speed:
Spin:
Elevation:
Horizontal Angle:
conrm it’s activated). The maximum interval during
the 2 Line Drill - wide setting is 17 and for the 2 Line
Drill - medium it’s 19. Note that the balls will not
start ejecting from the machine until you press the
FEED (start/stop) button.
This sets the speed at which the balls are propelled.
It can be set from 0 – 20 with 20 being the fastest
speed (approximately 80mph or 130km/h) and 0
being the slowest (approximately 20mph or 32km/h).
You can set the speed to vary automatically by +/- 1
value by pressing the VERTICAL button (an “R” will
appear next to the value to conrm it’s activated).
Note, slower speeds can be achieved by adding
spin.
Using this setting, you can add topspin or slice to
each ball. It can be set from -10 to +10. When set
to -10 you will achieve the highest level of slice.
When set to 0 you will have at balls while +10
represents the highest level of topspin. You can also
set mild levels of spin. You can set the spin level to
vary automatically by +/- 1 value by pressing the
VERTICAL button (an “R” will appear next to the
value to conrm it’s activated).
By pressing the UP and DOWN buttons you can
adjust the level of elevation, or you can do it via the
menu as described above. It can be set from 0 –
200 with the highest elevation being 200 (use this
setting for lobs). You can set the elevation to vary
randomly (see “Vertical Random” below) by pressing
the VERTICAL button (an “R” will appear next to the
value to conrm it’s activated).
You can vary the horizontal angle that balls are
ejected to by pressing the LEFT and RIGHT buttons.