15
Feed start/stop:
Single Spot:
Vertical Random:
Note, you can only adjust the horizontal angle when
the menu is not ashing.
This allows you to start and stop the feeding of balls
from the machine. If you would like to have a 15, 30,
45 or 60 second delay before balls start feeding (to
give you time to get to the other end of the court),
simply hold the FEED button when turning it on.
It will begin by showing a 15 second delay but if
you continue to hold the button, it will display 30,
45 then 60 seconds. If you continue to hold the
button past the 60 second display, it will assume
your selection is 60 seconds and the countdown will
begin. This is useful when you don’t have the remote
control.
If you simply wish to re balls to a single location
repeatedly, you start by setting your desired interval,
speed & spin, horizontal angle and also the elevation
height. Then you press the FEED (start/stop) button
to begin. We suggest you re one ball to begin with
and then press FEED (start/stop) again to pause
the machine. If you are happy with the rst ball you
red, then you may begin practice. Otherwise, you
may like to rene your settings and re another test
ball until you are happy with the result. You can then
press FEED (start/stop) to start balls ring and begin
play.
Once pressed, the machine will randomly re short
and deep balls to two dierent depths. The elevation
height will be adjusted by 4 degrees, randomly
choosing when to shoot a higher/deeper ball and a
lower/shorter ball. For example, you may get 3 deep
balls followed by 2 short balls then 1 deep ball and
then 3 short balls. It’s totally random. Press this
button again to cancel the Vertical Random
.
This
setting can be turned on while using other settings
To Next Page
Loading...