21
6. Commissioning
6.1 General information
All commissioning for the product is carried out via the front panel.
Warning: On entering the commissioning mode the product will cease normal
control. The control relay will switch off the pump. For safety, the alarm relay will
continue to operate as normal. To regain normal control, return to the run menu by
selecting end.
Warning: If during commissioning, the buttons are not pressed for over 5 minutes, the
controller will revert to run mode and an error will be displayed. If the commissioning
was incomplete the controller may not provide the correct control.
Fig. 12
Display screen and keypad
Test the alarm
Enter commissioning
mode (five seconds)
and parameters / digits
(when flashing)
Scroll up the menu
and increment digits
Manually switch
on the pump
(Commission
mode only)
This button has no
function
OK
AL
LC1350
6.2 The product has no battery
The programmed settings are held in non-volatile memory (flash) and are written to after
changing a parameter and pressing the
To Next Page
Loading...
Need help?
General
