Initial Installation
Management Port Configuration
Spirent Landslide Test System Installation Guide | 27
14 The user will be prompted to configure the alternate IPv4 Address mode for any
desired services that may require the use of IPv4. For example, if IPv4 addresses were
used in provisioning NTP or PTP in the steps above, configuration of the IPv4
Address mode is required. If no alternate IPv4 management interface is desired or
needed, press Enter to accept the default value none to skip this step. Otherwise,
specify static or dynamic to continue with configuring an alternate IPv4 management
address.
Configure <TAS / TS / TAS+TS> alternate IPv4 Address mode
(none/static/dynamic) [none]:
If static is selected, answer the resulting configuration prompts.
• Specify a unique IPv4 address for the alternate IPv4 management address then
press Enter to continue.
<port> <TAS / TS / TAS+TS> IPv4 Address []:
• Specify the IPv4 network mask, then press Enter to continue.
<port> <TAS / TS / TAS+TS>
IPv4 Network Mask []:
• Specify the address for the IPv4 gateway in your network, then press Enter to
continue.
<port> <TAS / TS / TAS+TS>
IPv4 IP Gateway []:
The initial configuration is complete at this point. Type yes and press Enter to reboot
the system.
System must be rebooted for these changes to take effect…
Reboot now? (yes/no) [yes]:
Note: If errors are detected in any of the data entered above, answer no to the reboot
question and rerun the
ipcfg command.
To Next Page
Loading...