Installing U1 OTA Modules on the Landslide E10
Introduction
36 | Spirent Landslide Test System Installation Guide
Introduction
The U1 over-the-air module adds expanded RF-testing capabilities to Landslide systems.
While designed to work with E10 test servers or stand-alone systems, the U1 is
compatible with any Landslide system equipped with one or more USB connections.
Before You Begin
Package Contents
Check the contents of the package to ensure it is complete.
Each U1 LTE OTA module is shipped with:
• 1 U1 OTA Module
• 2 LTE antennas
• 2 USB cables
• Instruction sheet
Each E10 Carrier for U1 is shipped with:
• 1 E10 Carrier for U1
• Instruction sheet
Important: • Refer to “Federal Communication Commission Interference Statement”
for important information pertaining to RF transmitters.
• It is highly recommended that you review all Release Notes before you
install or use the Landslide E10 appliance and OTA Modules.
To Next Page
Loading...