Spirent Landslide EDGE E10 - Page 53

Appendix A: Landslide Test Server NIC Configurations
Supported NIC Configurations and Port Names
Spirent Landslide Test System Installation Guide | 53
C100-M4 and C50-S4 Test Server Supported NIC Configurations
The following tables describe the NIC configurations that are supported on the C100-M4
and C50-S4 test servers.
Notes: • Slots 0 and 6 are unused
• L-ACC-007 is optional for all C50-S4 and C100-M4 configurations
• C100-M4 test servers support one or two L-ACC-007 IPSec accelerator
cards; contact Spirent Customer Support for information about supported
configurations (refer to page 11 for contact details).
• L-ACC-008 can be used in lieu of L-ACC-007 in C100-M4 configurations
only.
Table A-2. One, two, three, or four quad-port 1 Gbps, 4x, 8x 12x or 16x 1 Gbps ports
Slot Card Ports
0 Unused NA
1 First quad-port, 1 Gbps eth2, eth3, eth4, eth5
2 Second quad-port, 1 Gbps eth6, eth7, eth8, eth9
3 Fourth quad-port, 1 Gbps eth14, eth15, eth16, eth17
4 Third quad-port, 1 Gbps eth10, eth11, eth12, eth13
5 Optional L-ACC-007 or L-ACC-008
IPSec Accelerator
NA
6 Unused NA
Table A-3. One or two quad-port 10 Gbps NICs with no additional NIC cards, 4x or 8x 10
Gbps ports
Slot Card Ports
0 Unused NA
1 First quad-port 10 Gbps (L-NIC-66) eth2, eth3, eth4, eth5
2Empty NA
3Empty NA
4 Second quad-port 10 Gbps (L-NIC-66) eth6, eth7, eth8, eth9
5 Optional L-ACC-007 or L-ACC-008
IPSec Accelerator
NA