SPT-299CZ-02
9
High temperature treatment
After stopping the operation of the machine, the engine and
engine oil, cooling water and hydraulic oil will heat up in a short time.
There may also be a small amount of pressure build-up in the hydraulic
oil tank. At this time, if you check the engine, remove the radiator cap,
drain oil, drain water, or replace the filter, it will cause burns.
Wait until the temperature drops, and then proceed in the
following order. In order to prevent the discharge of high-temperature
oil, stop waiting for the oil temperature to drop.
When you loosen the cover, slowly rotate and release the
pressure, and then loosen the cover. (To measure the drop in oil
temperature, place your hands near the surface of the hydraulic oil
tank or similar (make sure there is no contact).
Don't let any part of the body be pinched：
Between the boom and the mobile trolley.
Between the outriggers and the ground.
Between the boom swing and the boom cylinder.
Between the winch drum and the wire rope.
Inhalation of asbestos may cause lung cancer. This machine does
not contain asbestos, but asbestos may be found on the walls, ceilings
or other construction locations in the machine's construction site. In
addition, when handling materials that may contain asbestos, please
pay attention to the following：
Wear the designated dust-free mask and/or other protective
equipment when necessary.
Do not use compressed air for cleaning.
Sray water when cleaning to prevent asbestos dust in the air.
When driving the machine in a location that may contain asbestos
dust, always work in a windward position.
To Next Page
Loading...