3. Start the engine
1. Insert the key into the master key switch (19), at this time in the
"stop" position, turn clockwise to the "on" position, the crane circuit is
connected, and the display shows the machine working condition
information.
2. Turn clockwise from the "on" position to the "start" position.
After about three seconds, release the key, reset to the “on” gear
counterclockwise, and the engine will start normally.
3. Pull the throttle lever (No. 7) backward to run the engine at a
medium speed (the throttle lever is in the middle position).
To Next Page
Loading...