SPXFLOW C Series - Page 33

Maintenance Waukesha Cherry-Burrell
®
Brand C-Series Pump
01/2019 95-03008-IEC Page 33
7. Remove the water cascade attachment from the adapter (if
included). See Figure 22, item A.
8. Remove the gasket from the pump backplate and inspect it
for wear and sealing failure. Replace if necessary.
9. Loosen the impeller nut.
NOTE: You ca
n keep the impeller from turning by placing an
Allen wrench on the shaft collar screw.
10. Remove the impeller nut from the stub shaft.
WARNING
The pump components and piping may contain sharp edges.
Handle the impeller carefully because edges may be sharp. Wear
gloves while installing and servicing the pump to help avoid
injuries from these hazards.
Figure 58 - Remove water cascade
Figure 59 - Remove casing gasket
Figure 60 - Loosen impeller nut
Figure 61 - Remove impeller nut