SPXFLOW C Series - Type DG Seal Assembly Option

Parts Lists Waukesha Cherry-Burrell
®
Brand C-Series Pump
Page 72 95-03008-IEC 01/2019
Type “DG” Seal Assembly Option
Notes:
* Recommended Spare Parts
1. The C-100 is not available with “DG”, “E”, or “F” seals.
4. Contact factory if passivation or optional finish is required.
6. There is no pin on the C-114 backplate.
7. Studs (17K) and pins (17L) are included with the backplate if purchased as a spare part.
8. 17M Lock washer: C-114 needs a qty. of 1; C-216, C-218 & C-328 need a qty. of 4.
9. To convert from a D seal to a DG seal, you need: DG Conversion kit x1, item 80 x1 and 80B x1.
80A
80
17N
17M
17J 80P
80N
80R
17K
11H
80B
80C
80L
80K
CT100-625
C-114 C-216
C-218
C-328
11H
Backplate 1 60481+ 60482+ 60483+ 4, 6, 7
17J
Gland Ring 1 60484+ 60485+ 60486+
17
K
Stud 4 60890+ 60888+ 60888+ 7
17L
Pin (attaches to backplate, not shown) 2 N/A 60013+ 60013+ 6, 7
17M
Lock washer
Note 8
43-22 43-15 43-15 8
17N
Nut 4 36-53 36-41 36-41
Inboard Rotary Seal, Tungsten Carbide 1 113663+ 113665+ 113667+
Inboard Rotary Seal, Silicon Carbide 1 113664+ 113666+ 113668+
Inboard Rotary Seal, Carbon 1 60085+ 60086+ 60087+
80
A
Seal Cup 1 60088+ 60089+ 60090+
O-Rin
g
, Buna N
N70210 N70216 N70222
O-Rin
g
, FKM
V70210 V70216 V70222
O-Rin
g
, EPDM
E70210 E70216 E70222
80C
Spring 1 60091+ 60092+ 60093+
80
K
Set Screw 2 30-662 30-178 30-178
80L
Drive Collar 1 60094R1 60095R1 60096R1
Inboard Stationary Seal, Silicon Carbide 1 113670+ 113673+ 113676+
Inboard Stationary Seal, Ceramic 1 113671+ 113674+ 113677+
Inboard Stationary Seal, Tungsten Carbide 1 113669+ 113672+ 113675+
Inboard Stationary Seal, Siliconized Graphite 1 60374+ 60375+ 60376+
* 80P
PTFE Gasket - Outboard; 1/16" (1,587 mm) thick 1 60377+ 60378+ 60379+
* 80R
PTFE Gasket - Inboard; 1/8" (3,175 mm) thick 1 60760+ 60761+ 60762+
DG Conversion kit 1 60506+ 60507+ 60508+ 9
PL5050-CH6a
19
*80
* 80N
NOTES
PART NO.
ITEM DESCRIPTION QTY.
9
* 80B