Parts Lists Waukesha Cherry-Burrell
®
Brand C-Series Pump
01/2019 95-03008-IEC Page 55
C-100 Pump Parts
Notes:
* Recommended Spare Parts - also available in kits (see page 74)
1. For casings with Bevel threaded, Female I-Line, NPT or Flanged connections, please contact factory.
4. Contact factory if casing drain, passivation, or optional finish is required.
5. For a pump shipped prior to approx. April 1999: item 11 or item 71 alone will not work; need both the backplate (item
11) and adapter (item 71) as well as a casing O-ring (item 90). Contact factory with serial no.
9. Applies only to the Sealed Impeller Design.
10. Does not apply to the Sealed Impeller Design; applies only to the Pin Impeller Design.
11. Contact your local distributor for other impeller sizes and finishes.
12. C-100 is not available with DG or E seals. Standard “D” type is shown.
ITEM DESCRIPTION QTY. PART NO. NOTES
1
Casing, 1,5" x 1" (38,1 x 25,4 mm) with ISO 2852 clamp 1 60000+ 1, 4
C100 Impeller - Pin Impeller Design, Full, 3,68" (93,5 mm) dia., 32
Ra finish
60026+ 10, 11
C100 Impeller - Sealed Impeller Design, Full, 3,68" (93,5 mm) dia.,
32 Ra finish
138526+ 9, 11
3
Impeller Nut - Sealed Impeller Design 1 138531+ 9
Impeller Nut O-rin
n, BUNA N
N70116
Impeller Nut O-rin
n, FKM
V70116
Impeller Nut O-rin
n, EPDM
E70116
5
Shaft Collar - Sealed Impeller Design, D71 Frame 1 138567+ 9
Stub Shaft, D71 Frame 60740-1E 10
Stub Shaft, Sealed Impeller Design, D71 Frame 138537+ 9
6
Shaft Set Screw, D71 Frame 3 30-714 10
7
Impeller Key - Sealed Impeller Design 1 138584+ 9
Stub Shaft O-rin
n, BUNA N
N70116
Stub Shaft O-rin
n, FKM
V70116
Stub Shaft O-rin
n, EPDM
E70116
11
Backplate 1 60597+ 4
* 24 Impeller Retaine
1 60039+
40
Deflector, D71 Frame 1 60042+ 10
71
Adapter, D71 Frame, 304SS 1 60741+
71B
Adapter Mounting Bolt, D71 Frame: M8x30 with Nut 4 N/A
75
Wing Nut 2 60083+
* 80 Inboard Rotar
Seal Cup 1 60088+
Seal O-Rin
, Buna N
N70214
* Seal O-Rin
, EPDM
E70214
80C
Spring 1 60091+
Casin
, EPDM
E70153
PL5050-CH9
*4
19
2
1
80B
90
1
1
6
*8
19
1