Spypoint FORCE-PRO - Page 5

5
FORCE-PROSPYPOINT
NO GLOW FLASH
Night lighting to obtain black-and-white photos and videos.
RED LED INDICATOR
When the button is in the SETUP position and you’re done adjusting
your settings, the red light at the front of the camera will flash to
confirm a motion detection. When moved to the ON position, the red
light will flash for 30 seconds to allow the user to walk away without
being photographed.
PHOTO LENS
Image sensor.
DETECTION LENS
Enlarges the detection area of the camera’s motion sensor.
CABLE LOCK HOLE
Allows you to install a #CLM-6FT padlock cable to secure the unit
(sold separately).
SLOT FOR INSTALLATION STRAP
Allows the camera to be installed using
the included installation strap.
LOCKABLE DOOR LATCH
Allows you to lock and open the door of the camera.
12 V JACK
Allows you to insert a power cord connected
to an external 12 V source.
SCREWTHREAD FOR STANDARD ¼”20
Allows you to attach a standard tripod from ¼“-20.
LCD SCREEN
Allows the user to access the camera's settings menu.
OK BUTTON
Allows the user to confirm a selection.
SWITCH ON/SETUP/OFF
Allows the user to turn the camera ON and OFF, as well as access
the configuration menu.
NAVIGATION BUTTONS
Buttons to navigate the camera’s menus and set the camera.
SD CARD SLOT
Space to insert the SD card (not included) needed to save photos
and videos.
BATTERY COMPARTMENT
Space to insert 8 AA batteries.
DOOR
Provides access to the battery compartment,
ON/SETUP/OFF switch, navigation buttons,
configuration screen and SD card slot.
Components