SRAM Guide Ultimate

10Caliper Piston Removal
Use a T25 TORX
®
wrench to remove the banjo bolt. Remove the Guide
Ultimate pad spreader.
Use a 2.5 mm hex wrench to remove the pad retention bolt.
Use a T25 TORX
®
wrench to remove each caliper body bolt.
Separate the caliper body halves.
Set the heat shield aside.
3
T25 TORX wrench Rubber-tipped blow gun chuck nozzle 22 mm
4
2.5 mm hex wrench QR
5
T25 TORX wrench Rubber-tipped blow gun chuck nozzle 22 mm
6