Software description
Settings window (Main tab)
Maximum Hits — preset how quick a maximum color is achieved.
Annihilation Time — the afterglow time setting.
High Color Correction — setting for the "upper" color level (the gradation
downwards in the color scheme).
Low Color Correction — setting for the "lower" color level (the gradation upwards in
the color scheme).
Stile — the style of the display: with (area) or without (line) colored filling below the
spectrum.
Area Color — the color of the filling.
Area Transparency — the transparency of the filling.
Spectrum section
Herewith the spectrum display can be adjusted.
Style — the style of the display: with (area) or without (line) colored filling below the
spectrum.
Line Width —the width/thickness of the line.
Line Color — the color of the line.
Area Color — the color of the filling.
Area Transparency —the transparency of the filling.
Filter Color — the color of the frequency mark and the filter bandwidth on the
spectrum display.
Filter Transparency — the transparency of the filter bandwidth.
CW Color — color of the CW side tone marker.
CW Transparency — the transparency of the CW side tone marker.
RIT/XIT Color — the color of the transmission frequency marker in RIT, XIT and SPLIT
modes.
RIT/XIT Transparency — the transparency of the transmission frequency marker in
RIT, XIT and SPLIT modes.
Inverse when CTRL key down – inversion of the CTRL key action for frequency tuning.
Waterfall section
Herewith the waterfall display can be adjusted.
Frequency History — on/off switch for the horizontal shift of the waterfall display,
synchronously to a change of the spectrum bandwidth.
Color Scheme — selection of color scheme.
SSB-Electronic GmbH © Page 35 of 88 V2.8.1 Content is protected by Copyright.
To Next Page