SSB-Electronic Zeus-1 - 6 Precautions

To Next Page

To Previous Page

Precautions

 The transceiver and other equipment has to be grounded; missing grounding can

be the reason of electrical shock to the operator or can lead to malfunctions.

 Immediately turn the transceiver power OFF and remove the power cable if it

emits an abnormal odor, sound or smoke.

 Do not open the transceiver. Unauthorized opening can cause the loss of

warranty.

 Do not start to transmit without antenna. Broadcasting without antenna or end

load can damage the transmission stage!

 Connect the transceiver only to a stabilized supply voltage with 12-15 V DC and at

least 5 A. SSB-Electronic recommends the optional power supply Art.-No. 9371, as

it was tested with the Transceiver in continuous operation

 Never apply more than 15 V DC to the 12-15 VDC jack on the transceivers rear

panel. This could cause a fire or damage the transceiver

 Never expose the transceiver to rain, snow or any liquids.

 Do not use chemical agents such as benzine or alcohol when cleaning the trans-

ceiver, as they can damage the transceivers plastic surfaces and marking.

 Do not use or place the transceiver in areas with temperatures below 0 °C or

above +50 °C.

 Avoid the formation of frost and condensation.

 Set the transceiver so that free air circulation is ensured. Do not place any other

objects on the unit, to avoid overheating.

 Turn the transceiver power OFF and disconnect the DC power, antenna and USB

cables when you will not use the transceiver for long period of time.