Software description
Predistortion Setup
4 Comments Field
Comment input field to a given set of settings.
5 Buttons for selection of band-dependant predistortion algorithms
6 Mode A, B, C Buttons
Button selects one of three predistortion algorithms.
7 Max Power Parameter
Max Power parameter sets the maximum output power of the transceiver with an
external amplifier in the selected frequency range, ie limits the maximum value for
the ZS-1 Signal and Carrier power adjustment in the main program window.
8 Alfa, Beta, Gamma Parameters
The coefficients of the predistortion algorithm for the selected frequency band.
For coarse adjustment parameter can be set by arrows up / down in the input
field or rotate the mouse wheel. Keyboard input of a certain value is also possible.
9 Enable Button
Enable / disable the predistortion algorithm in the selected frequency range.
10 Spacing List
Drop-down list, selects the separation of the two tones.
11 Power Field
Field for the power of two-tone signal (PEP).
12 2-tone TX Button
On/off switch for two-tone signal transmission with given power and spacing
between tones.
The controls located in the section intended for Low Power setting algorithms at a
low output power (LPW), to be activated by pressing "LPW" in the main window.
SSB-Electronic GmbH © Page 45 of 88 V2.8.1 Content is protected by Copyright.
To Next Page
Loading...