Software description
HIQSDR
At the top of the window the bit rate is only displayed, while the temperature,
supply voltage and current consumption are absent.
GETTING STARTED WITH HIQSDR UNDER ZEUSRADIO CONTROL THE S-METER
MUST BE CALIBRATED. To do this, apply to the input of the transceiver the signal
with known level and achieve appropriate S-meter readings by changing the S-
meter correction parameter in the Settings window. More convenient to perform
the calibration in the digital mode of the S-meter using the Filter value – the signal
level in the filter expressed in dBm.
SSB-Electronic GmbH © Page 52 of 88 V2.8.1 Content is protected by Copyright.
To Next Page