Basic operation
RIT, XIT and SPLIT modes
Changing the frequency of RIT / XIT offset possible in several ways.
You can enter the offset from the keyboard or adjust it by simply rotating the
mouse wheel in the RIT/XIT offset field.
Also, holding down the Shift button on the keyboard, you can drag with the
mouse the white dashed line (receiving frequency indicator) in RIT mode or the red
dashed line (transmission frequency indicator) in XIT mode. Or simply holding Shift,
click the mouse in the desired region of the spectrum - the frequency of reception
or transmission will shift to this point of the spectrum.
The same way hold the Shift on the keyboard and use your mouse to move the
transmission frequency in SPLIT mode.
SSB-Electronic GmbH © Page 55 of 88 V2.8.1 Content is protected by Copyright.
To Next Page