OPERATION (cont.)
Starting and Riding
Starting the engine. Be sure the transmission is
in neutral and that (if applicable) the two-position
on/off switch is in the ride (on) position. Turn the
three position fuel petcock to the “ON” position. If
the bike’s engine is cold, lift the choke lever up to
the fully “ON” position. Next, shift the transmission
into neutral and, for added safety pull the clutch in
against the handlebar grip to disengage the clutch,
then hold the throttle slightly open and follow the
following directions to operate the kick-starter.
Petcock ON
Petcock OFF
Petcock RESERVE
28
To Next Page
Loading...