Wheels
SERVICE MAINTENANCE,
LUBRICATION AND
ADJUSTMENTS (cont.)
Maintaining correct spoke tension and trueness
(roundness) of the wheels is critical to safe motor-
cycle operation.
During the rst hour or two, spokes will loosen
rapidly due to the initial “seating” of the parts. Ex-
cessively loose spokes may result in instability at
moderate and high speeds leading to a
possible loss of control. It’s also important that the
rim locks are secure to prevent tire slippage.
It is not necessary to remove the wheels to perform
the recommended services in the
Maintenance Schedule. However, information for
wheel removal is provided for emergency
situations.
1. Inspect the rims and spokes for damage.
2. Tighten any loose spokes.
3. Rotate the wheel slowly to check for signs of
wobble. If the wheel appears to wobble, the rim
is out of round or not “true.” If the wobble is
noticeable, see your dealer for inspection.
52
To Next Page
Loading...