Need help?Do you have a question about the SST SST-PFB-SLC and is the answer not in the manual?
Explains the manual's scope and procedures for the SST-PFB-SLC scanner.
Lists necessary tools and equipment for scanner setup.
Guides through setting up and running the scanner.
Instructions for physically installing the scanner into the SLC chassis.
Details ProfiBus wiring, pinouts, and line types.
Explains scanner configuration using APS, PLC-500, or RS Logix 500.
Guides on creating I/O configurations using the SST ProfiBus Configuration Tool.
Details creating I/O configurations using Siemens COM PROFIBUS software.
Instructions for transferring the I/O configuration file to the scanner.
Explains scanner operation and associated fault codes after configuration.
Explains configuring received data length and location for DP slave operation.
Details setting transmit data length and location for DP slave operation.
Details setting up and sending FDL messages using control blocks and commands.
Details the step-by-step procedure for loading new firmware into the scanner.
To Next Page
General