SST SST-PFB-SLC - 7.5 Using the Module Only as a DP Slave

SST-PFB-SLC User’s Guide
56
7.3 Displaying the DP Slave Configuration
If you issue the ShowSlv command from the serial port, the module displays
the DP slave configuration.
Example
If you use the ShowSlv command after issuing the configuration commands
in the previous examples, the scanner displays:
DP Slave Configuration:
SlvTxLen O:x.31 Len=1 M0:x.1000 Len=100
SlvRxLen I:x.30 Len=2 M1:x.1000 Len=10
7.4 Disabling DP Slave Operation
To clear the DP slave configuration data and disable DP slave operation,
issue the ClrSlv command from the serial port.
7.5 Using the Module Only as a DP Slave
If you use the scanner module only as a DP slave, set several network
parameters from the serial port before putting the module online. At
minimum, set the local station number and the baud rate and make sure that
the station is passive, not active. The module sets appropriate default values
for the remaining network parameters.
If the station is to be active, and if there are repeaters or FMS devices on the
network, set network options so that the module can set appropriate values for
the network parameters. Most of them are not needed if the station is passive.